[Elecraft] {K3} Split when changing bands?

[Gary K9GS]

OK...I got this figured out.

I have SPLT SV set to "on" in the CONFIG/TECH MD menu.

As long as I change bands with the K3 and NOT by clicking on a spot in 
the logging software, the K3 operates like it's supposed to....NOT 
turning off split and remembering the split setting by band.

However, if I change bands by clicking on a spot in the logging software 
the logging software turns off the split when it changes bands.  Thanks 
to Joe W4TV for suggesting I check this.

I confirmed this with both Logger32 and N1MM.

I do not believe there is a way to defeat this with either logging 
program, unfortunately.  At least for day-to-day operating with Logger32 
that would be nice to be able to select the split behavior.

Thanks for all the responses on and off the reflector.


On 11/13/2012 11:05 PM, Gary K9GS wrote:
> On the K3....say you're on 160M with split activated and the sub
> receiver turned on.  Then you change bands to, say 80M.  A few minutes
> later you go back to 160M.
>
> The K3 goes back to the original VFO A and VFO B frequencies as before
> but the SPLIT deactivates.  I thought that by turning SPLT SV to "ON" in
> the config menu would stop this from happening but it didn't.
>
> Is there some other command I'm missing?
>
>
>

-- 


73,

Gary K9GS

Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032   http://www.cwops.org

************************************************