[Elecraft] {K3} Split when changing bands?

[Gary K9GS]

On the K3....say you're on 160M with split activated and the sub 
receiver turned on.  Then you change bands to, say 80M.  A few minutes 
later you go back to 160M.

The K3 goes back to the original VFO A and VFO B frequencies as before 
but the SPLIT deactivates.  I thought that by turning SPLT SV to "ON" in 
the config menu would stop this from happening but it didn't.

Is there some other command I'm missing?



-- 


73,

Gary K9GS

Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032 http://www.cwops.org

************************************************