[Elecraft] KX3 S/N 2294 doen't start

[Matt Zilmer]

Yes.  What Jim said too.

matt

On Sun, 04 Nov 2012 08:38:12 -0500, you wrote:

>Make sure as well that the flex cable is plugged in correctly.  I suggest reviewing the section of the manual.
>
>73
>
>Jim WB8AZP
>
>Sent from my iPhone
>
>On Nov 4, 2012, at 8:15 AM, Matt Zilmer <mzilmer at verizon.net> wrote:
>
>> Try re-seating the flex cable between RF and FP boards.
>> 
>> matt W6NIA
>> 
>> On Sat, 03 Nov 2012 21:03:34 +0100, you wrote:
>> 
>>> Hi, just assembled the Kit S/N 2294 with KXAT3 and KXFL3. No problems 
>>> during assembly. I used anti static wristband and mat.
>>> 
>>> Tried 12V battery and linear power supply. While pressing BAND- and ATU 
>>> TUNE the four LED light up. After releasing the buttons the LEDs switch 
>>> off and the display backlight turns on. That's all. No display, no 
>>> message,s no sound. Nothing. And the KX3 won't switch off.
>>> 
>>> 
>>> Any suggestions?
>>> 
>>> 
>>> regards
>>> Holger - DL9HDA
>>> ______________________________________________________________
>>> Elecraft mailing list
>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>>> Help: http://mailman.qth.net/mmfaq.htm
>>> Post: mailto:Elecraft at mailman.qth.net
>>> 
>>> This list hosted by: http://www.qsl.net
>>> Please help support this email list: http://www.qsl.net/donate.html
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html