[Elecraft] KX3 S/N 2294 doen't start

[James kvochick]

Make sure as well that the flex cable is plugged in correctly.  I suggest reviewing the section of the manual.

73

Jim WB8AZP

Sent from my iPhone

On Nov 4, 2012, at 8:15 AM, Matt Zilmer <mzilmer at verizon.net> wrote:

> Try re-seating the flex cable between RF and FP boards.
> 
> matt W6NIA
> 
> On Sat, 03 Nov 2012 21:03:34 +0100, you wrote:
> 
>> Hi, just assembled the Kit S/N 2294 with KXAT3 and KXFL3. No problems 
>> during assembly. I used anti static wristband and mat.
>> 
>> Tried 12V battery and linear power supply. While pressing BAND- and ATU 
>> TUNE the four LED light up. After releasing the buttons the LEDs switch 
>> off and the display backlight turns on. That's all. No display, no 
>> message,s no sound. Nothing. And the KX3 won't switch off.
>> 
>> 
>> Any suggestions?
>> 
>> 
>> regards
>> Holger - DL9HDA
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html