[Elecraft] KBT2 Instructions for the K2 Internal Battery

[Tom McCulloch]

That switch!!

That switch has caused more problems that it was worth -- it seemed that 
every time I would take the cover off of my K2, for whatever reason, and 
then replace it, I'd turn on the rig and get the infamous "Lo batt" 
message because my fat fingers accidentally pushed That Switch to the 
wrong position.  Off came the cover, the switch was set properly, back 
on went the cover and everything was fine --- until the next time.

Glad to see it's gone...hi  (althiugh as Keith points out, even though 
it's gone, it's still causing problems...hi)

(what was it for, anyway?
Tom, WB2QDG

K2 # 1103

On 5/22/2012 9:31 PM, Keith Hamilton wrote:
> The KBT2 Internal Battery Installation Instructions need to be
> updated or have a errata attached. The instructions on page 8
> refer to a "S1" switch on the control board. I searched the
> archives and found out that the switch was changed to 3 pin header
> "P7" after about serial number 3000 or so.
>
> So to prevent others from this confusion the instructions need
> changed or added to.
>
> 73
> Keith Hamilton N8CEP
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>