[Elecraft] KBT2 Instructions for the K2 Internal Battery

[Don Wilhelm]

Keith,

You are correct.  I will *try* to see who is owner of the document and 
see if it can be corrected.
I am glad to see that you did enough research to realize that the switch 
had been changed to a 3 pin header.

73,
Don W3FPR

On 5/22/2012 9:31 PM, Keith Hamilton wrote:
> The KBT2 Internal Battery Installation Instructions need to be
> updated or have a errata attached. The instructions on page 8
> refer to a "S1" switch on the control board. I searched the
> archives and found out that the switch was changed to 3 pin header
> "P7" after about serial number 3000 or so.
>
> So to prevent others from this confusion the instructions need
> changed or added to.
>
> 73
> Keith Hamilton N8CEP
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>