[Elecraft] K3 reset/reboot

[Thomas Horsten]

Try restoring an old configuration and/or upgrading the firmware with the
K3 utility from a PC. Sounds not so good to me though...

73, Thomas M0TRN

On 24 March 2012 00:11, M. <htrn727 at yahoo.com> wrote:

> My K3 has lost its mind.
>
> The K3 has been sitting off the operating table for a couple of months
> (sacrilege I know!). Tonight I hooked it back up and powered up and while
> the display looks ok, none of the buttons function as they should. Most of
> them do nothing, others are mis-mapped, i.e. Mode ^ toggles ANT1/2, Mode
> (dwn) toggles RX/ATT, XMIT turns the preamp on and off .....
>
> Tried the Shift/Power Up trick to reset and no joy. Of course it doesn't
> respond to any serial communications.... Checked the internal coin cell and
> its ok ...
>
> Any tricks I'm missing? Hopefully not a trip back to the mothership.
>
> 73, Mike N4GU
> K3 #01710
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>