[Elecraft] P3SVGA 1920x1080

[Bruce Beford]

Thanks, Byron, but I have already done this. No joy. The 1920x1080 is a 16:9
mode, so no cropping or stretching should be applied by the monitor.
-Bruce, N1RX

-----Original Message-----
From: Byron Servies [mailto:byron at n6nul.org] 
Sent: Thursday, March 22, 2012 6:22 PM
To: Bruce Beford
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] P3SVGA 1920x1080

Hi,

I would suggest checking your monitors settings to make sure it is not
in a "full" compatibility mode (the names seem to change.  It might be
different for your monitor).  That is, the monitor can expand a 4x3
image to fit the 16x9 HD image vertically and thus chop off parts of
the image on the sides and eliminate the "black bar" problem.

Just an idea,

73, Byron N6NUL

On Thu, Mar 22, 2012 at 3:09 PM, Bruce Beford
<bruce.beford at myfairpoint.net> wrote:
>
> I installed the P3SVGA board in my unit yesterday. On mine, it also does
not
> display properly in 1920x1080. I have an Acer H243H monitor. It natively
> supports "Full HD", 1920x1080p. When I set the P3 SVGA output to
1920x1080,
> the monitor confirms that it has switched to that resolution. However, the
> P3 image appears to extend off the right of the screen. That is to say,
the
> full span to the right is not displayed.

-- 
- Northern California Contest Club
- CU in the 2012 Cal QSO Party 6-7 Oct 2012
- www.cqp.org