[Elecraft] K3 a few new user questions

[Ray Spreadbury]

Don
They were already set to OFF OFF in CONFIG: PTT--KEY, enabled VOX but still
same result - no power output!
Ray

-----Original Message-----
From: Don Wilhelm [mailto:w3fpr at embarqmail.com] 
Sent: 07 March 2012 13:39
To: Ray G3XLG
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 a few new user questions

Ray,

Check your CONFIG: PTT -- KEY menu entry and set it to OFF -- OFF then use
VOX when using Data modes.
Yes it is likely that the computer and/or MicroHam is setting either DRT or
RTS (or both) on.

73,
Don W3FPR

On 3/7/2012 8:23 AM, Ray G3XLG wrote:
> However whilst MVARI in N1MM decodes PSK31 signals fine, when i try to 
> transmit I get no power output&  instead I get a couple of error 
> messages on the K3 - Error PTT , Error KEY which in the K3 manual 
> saysits usually caused by an external device (the MicroHAM MKII?) shorting
KEY or PTT to ground.
> I've obviously got something setup wrong in either N1MM config or in 
> the MKII router. Any ideas please?
> Ray, G3XLG
>
>
> -----
> Ray G3XLG
>