[Elecraft] Recalling power output levels with K3

[Jim Bennett]

That's one for the Elecraft developers to answer here on the reflector…!

On   Thursday, Mar 1, 2012, at  Thursday, 9:36 AM, K4GM-George wrote:

> But must the K3 be used with a KPA500 for this to occur or is there a command in the config somewhere to tell the K3 to recall a power level for each band so that any amp can be used???
> 
> George K4GM
> 
> On 3/1/2012 11:58 AM, Jim Bennett wrote:
>> Each band. And it recalls the proper level depending of if the KPA500 is in standby or operate mode!
>> 
>> On   Thursday, Mar 1, 2012, at  Thursday, 8:43 AM, K4GM-George wrote:
>> 
>>> Does the K3 recall output levels ONLY when used with the KPA-500 or will
>>> it recall the levels for each band irrespective of the amp used ?
>>> 
>>> George K4GM
>>> ______________________________________________________________
>>> Elecraft mailing list
>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>>> Help: http://mailman.qth.net/mmfaq.htm
>>> Post: mailto:Elecraft at mailman.qth.net
>>> 
>>> This list hosted by: http://www.qsl.net
>>> Please help support this email list: http://www.qsl.net/donate.html
>> 
>>