[Elecraft] KX3 and KPA500

[Irwin Darack]

Please share your solution as I plan on powering the KPA500 with a KX3 too

Thanks, KD3TB

On Sunday, June 10, 2012, Adrian wrote:

> ACC2 IO     setting > LO=PTT (input; apply 0 V or ground to
>
> activate PTT)
>
>
>
> > I can't figure out how to set the ACC2IO on the KX3 so that it will key
> the KPA500 properly. I currently have the >ACC2IO in the off position. When
> I connect the cable between the ACC2IO and the PA Key on the back of the
> KPA500 it puts >the KPA500 in a transmit mode. I have to manually put the
> KPA500 in standby to receive and then Operate to transmit. I >have tried a
> number of different settings on the KX3 and KPA500 with no success.  What
> am
> I doing wrong?  (incidentally >the KX3 will drive the KPA500 to almost 200
> watts output).
>
>
>
> >Dave WA6DKN
>
>
>
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net <javascript:;>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>


-- 
Irwin KD3TB