[Elecraft] 2m Transverter keeps switching back to 6m

[Randy Farmer]

Are you running NaP3? I encountered the same thing and found you need to 
go into the NaP3 setup and set the highest frequency to 148 MHz. It's 54 
by default, so the rig control function of the software will always QSY 
you to 54.000 until you change it.

If you're not running NaP3, perhaps whatever rig control software you 
use needs a similar setup change.

73...
Randy, W8FN

On 06/09/2012 16:02, Ham Radio wrote:
> Quick question.  My K3 keeps switching back to 6m when I turn it to 2m.  It will go to any frequency on 2m and then a second later switches back to 54.0 MHz.  Any thoughts?
>
> In the middle of the VHF contest, will look this up in parallel.
>
> Thanks,
>
> Keith
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>