[Elecraft] K3/0

[Eric Jorgensen]

No, the mic cables I got plug in the back of the k3/100 and the k3/0. 

I discovered the problem *may* be that I was using the XMIT button on the k3/0. It seemed to work using the ptt on the mic. I always use the XMIT to key the radio.  Using XMIT button did key the radio but there was no audio. I have the k3/100 and k3/0 sitting next to each other so I can see everything that happens.   But I was called away by xyl to do something out of house with her just then and could not test thoroughly. 

Also when I key the mic ptt switch the 0 goes into cw for a few seconds but the 100 stays on sb. But this does not seem to cause any real problem. 

Thanks. 
Eric 
W1NEJ

Sent from my Apple iPhone

On Jun 9, 2012, at 3:42 PM, D Joyce <d_joyce at sympatico.ca> wrote:

> Eric:
> If you are using the factory cables RRK0CBL, then the microphone (MH2) plugs into the front panel of the K3/0, so I think you need to set the MIC SEL to fP.L (or H)
> 
> 73,  Doug  VE3MV
> 
> ----- Original Message ----- From: "Eric Jorgensen" <eric.jorgensen at me.com>
> To: <elecraft at mailman.qth.net>
> Sent: Saturday, June 09, 2012 2:47 PM
> Subject: [Elecraft] K3/0
> 
> 
>> Got my K3/0 and RemoteRigs this morning.
>> 
>> Everything works perfectly except transmit audio.  MIC SEL is set to rP.L.
>> 
>> Using factory cables, all set up like the book says they should be.
>> 
>> Any ideas?
>> 
>> Thanks
>> 
>> Eric
>> W1NEJ
>> 
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>