[Elecraft] JT-65A modes

[Joe Subich, W4TV]

 > I am using the Data A mode, USB, Mic-Line is set to ON,

Mic+Line is not applicable in DATA A - don't know how you get and
invalid configuration.

 >  PTT Key RTS-DTR

PTT/Key is only valid for the CAT port - if COM3 is normally your
control connection from HRD, etc. that's fine but you would be
better served to not tie up the CAT port for just PTT.

 > then a few seconds later it keys up and starts resend the message
 > again but stops when the clock hits 00 and goes into receive mode.

Sounds like a CW ID but that's too long for JT65HF and I don't see
any CW ID in either WSJT7 or WSJT9.

73,

    ... Joe, W4TV


On 7/19/2012 7:35 PM, telegrapher at q.com wrote:
>
> A fellow Elecrafter gave me his number and i called him because i wasn't making any progress with the problem of keying the radio with the WSJT program.  What it came down to was in the configuration table for WSJT.  There is a place for "PTT" port and mine was set on 0.  I suspected that might have something to do with it but had no idea what should be in there.  Ken said his was 3, what a magical number!  It worked for me as well.  So now the radio goes into transmit mode as it should.  End of one problem.
>
> I am using the Data A mode, USB, Mic-Line is set to ON, VOX Gain at 10, Antivox 000, TX delay 008 (min), PTT Key RTS-DTR
>
> Now what happens is that it transmitts the message i have selected and right about the 48 second mark it drops, then a few seconds later it keys up and starts resend the message again but stops when the clock hits 00 and goes into receive mode.
>
> If i was a kid this would be easy but being an old F*** its a bit more time consuming so i appreciate any all exibitions of patience.
>
> Larry
> W0OGH
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>