[Elecraft] K3 sub receiver no signals

[nr4c]

I saw that someone else suggested checking all the cabling.  Good idea. 
Also, press the "A>B" switch twice quickly (should see "A>B ALL" in VFO 
B window) to make sure both main and sub are on same freq, filters etc.

Oh, yeah, lyou DID turn ON the Sub-rec'ver.  Didn't you?

Let's see, check internal cabling, Antenna, settings.  Oh, how is your 
RF/AF gain controls set up.  I have separate RF gains, but the AF gains 
are set up so that the little knob is volume, and the larger one is a 
fader.  How are your set up?

./...bill  nr4c
On Sun, 01 Jul 2012 22:49:36 -0600, W0MU Mike Fatchett wrote:
> The 2nd receiver was hooked up to the bnc aux connector.  I had to
> change that.  However still no signals.  I have tried every
> combination of antennas etc.
>
> I suspect maybe there was an issue when I uploaded the new firmware.
>
>
> Mike W0MU
>
> W0MU-1 CC Cluster w0mu.net
>
> On 7/1/2012 9:33 PM, Bill Conkling wrote:
>> Check antenna wiring, and make sure you have selected an antenna for 
>> the
>> SUB.
>>
>> ...bill  nr4c
>>
>> -----Original Message-----
>> From: W0MU Mike Fatchett [mailto:w0mu at w0mu.com]
>> Sent: Sunday, July 01, 2012 10:32 PM
>> To: Elecraft Reflector
>> Subject: [Elecraft] K3 sub receiver no signals
>>
>> I installed this 2nd receiver quite some time ago.  I probably never
>> checked but i hear background noise in the sub receiver but no 
>> signals.
>> I suspect this is something stupid, can someone point me in a 
>> direction.
>>