[Elecraft] SHIFT - LO/HI Cut

[Matt Murphy]

Is it possibly on QRQ mode?

On Mon, Jan 30, 2012 at 5:23 PM, Tommy Alderman <aldermant at windstream.net>wrote:

> In tinkering with my K3 (s/n 4521)(Firmware 4.39) I have somehow managed to
> disable the ability to select Lo/Hi Cut and I cannot get SHIFT to shift my
> passband in the CW mode. Ironically both SHIFT and Lo/Hi Cut work fine in
> other modes, so I feel pretty sure I have a parameter set incorrect. With
> the LED's lit for SHIFT and WIDTH, in the CW mode, WIDTH works correct but
> when I move my SHIFT control, VFO B display shows 'FC  *0.54 (of course
> 0.54
> is my pitch setting).
>
> I have been going through both the K3 manual and Fred's book but so far I
> can find nothing that identifies my problem.
>
> Any help would be greatly appreciated!
>
> 73,
> Tom - W4BQF
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>