[Elecraft] SHIFT - LO/HI Cut

[Tommy Alderman]

In tinkering with my K3 (s/n 4521)(Firmware 4.39) I have somehow managed to
disable the ability to select Lo/Hi Cut and I cannot get SHIFT to shift my
passband in the CW mode. Ironically both SHIFT and Lo/Hi Cut work fine in
other modes, so I feel pretty sure I have a parameter set incorrect. With
the LED's lit for SHIFT and WIDTH, in the CW mode, WIDTH works correct but
when I move my SHIFT control, VFO B display shows 'FC  *0.54 (of course 0.54
is my pitch setting).

I have been going through both the K3 manual and Fred's book but so far I
can find nothing that identifies my problem.

Any help would be greatly appreciated!

73,
Tom - W4BQF