[Elecraft] P3 and CW signal not aligned perfectly

[Craig Smith]

Perhaps coincidentally, yesterday my P3 was also off by 30 Hz based on the carrier frequency of BCB stations.  It had been dead-on since I calibrated it over a year ago.  Haven't had time to explore further, but will recalibrate if this persists.

73   Craig   AC0DS


Craig Smith
1009 Alder Way
Longmont, CO  80503
craig at powersmith.net
303-834-7712

          






On 24, Jan2012, at 8:31 AM, nr4c wrote:

> On the P3 there is a menu function to calibrate the frequency.  Do this 
> and you can set it perfectly.
> 
> ...bc
> 
> On Tue, 24 Jan 2012 07:07:52 -0800 (PST), N0SA wrote:
>> I have a K3 with the P3 panadapter.
>> When I properly tune a CW signal in and us the SPOT and CW indicator 
>> I
>> notice that it is not centered in the P3 display. If I center it then 
>> it is
>> off by about 30 Hz.
>> It shows the same offset if I change filters and go to REV CW.
>> My SHIFT is centered.
>> Is this normal or do I need to check and adjust something?
>> Thanks
>> Larry Naumann  N0SA
>> 
>> 
>> --
>> View this message in context:
>> 
>> http://elecraft.365791.n2.nabble.com/P3-and-CW-signal-not-aligned-perfectly-tp7220640p7220640.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>