[Elecraft] Cannot get K3 into USB

[Keith Heimbold]

Update.  I feel pretty dumb right now.

I held down the button instead of cycling the switch and it worked fine. The switch was skipping over USB from LSB to CW for some reason if I depressed it too quickly. 

Keith
AG6AZ

Sent from my iPhone please excuse typos

On Jan 9, 2012, at 8:23 AM, "Arie Kleingeld PA3A" <pa3a at xs4all.nl> wrote:

> Did you try push&hold ALT to switch sideband?
> 
> Arie PA3A
> 
> Op 9-1-2012 16:51, Keith Heimbold schreef:
>> I ran into an issue this morning when trying to get on 6m that the K3 won't allow me to get on USB.  All modes are accessible besides USB. I then switched to 10m and it was doing the same thing.
>> 
>> On 12m and below the USB selection works. I reloaded firmware but it is still not working.
>> 
>> Last night it was acting glitchy after I was having a long QSO on 2m using the internal transverter. Even when I switched to 40m where by itself it changed frequencies during a QSO.
>> 
>> Any thoughts on what might be going on would be appreciated.
>> 
>> Thanks,
>> 
>> Keith
>> AG6AZ
>> 
>> Sent from my iPhone please excuse typos
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html