[Elecraft] K1 Transmitter problem

Dennis Rayfield ki3fdar at gmail.com
Wed Feb 29 05:55:17 EST 2012


Thanks.  I've checked that it is not in keyer test mode.  I was just not sure if the processor was resetting the power down.  I'm off to build an RF Probe.

Regards,

Denny - KI3F



On Feb 28, 2012, at 10:12 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> Dennis,
> 
> It sounds like you need to turn the manual to the Transmit Signal Tracing section in the back of the manual.
> Once you isolate the failure to a specific stage, we can help you isolate to the component level.
> Right now, all we can say is that there is a problem somewhere in the transmit path.
> You might want to check for soldering problems, unsoldered components or those where the solder did not flow out adequately onto both the component lead and the thru-plated hole.  Re-flow the soldering with a hot soldering iron - 750 degF if you used leaded solder, 800 degF if you used unleaded solder.
> 
> 73,
> Don W3FPR
> 
> On 2/28/2012 9:58 PM, Dennis Rayfield wrote:
>> I'm building a K1 and have everything finished and am at the stage for transmitter alignment and test.  I use the out menu to set the output to 3 watts, but when I put it into tune mode it immediately shows P0.1 on the display and there is no power out.  When I take it out of tune and go back to the out menu, that still shows 3 watts.
>> 
>> Any suggestions where I should start with this?
>> 
>> Thanks for any suggestions.
>> 
>> 


More information about the Elecraft mailing list