[Elecraft] KPA500 Z Bracket & Top Cover

[Roger Dallimore]

Hi Chuck,

Yes I have exactly the same issue with my KPA500.

73
Roger MW0IDX

On 11/02/2012 02:54, Chuck - AE4CW wrote:
> Just finished a KPA500 build and all went smoothly.  The only issue I see is
> that the Z-Bracket appears to be about 1mm taller at the front than at the
> rear.  The result is that the top cover protrudes above the front panel in
> the center by a small amount, perhaps 1mm.  At the rear the top cover is
> flush with the rear panel in the center...no protrusion at all.  This is a
> cosmetic issue but does detract a bit for the "fit and finish" of the rest
> of the KPA500 and the K3.
>
> Has anyone else seen this issue?  Thought I would ask before calling home.
> ---
> Chuck, AE4CW
>
>