[Elecraft] K3 SteppIR Controller

[Dick Dievendorff]

Juan:

The SteppIR picture here shows the connections:  

http://test.steppir.com/wp-content/uploads/2011/10/Y-Cable.pdf

The KPA500 ports are not used for frequency information to the SteppIR.
They're used for firmware load of the KPA500, KPA500 operation, and for
frequency control with a Kenwood radio.

73 de Dick, K6KR



-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of TG9AJR Juan Munoz
Sent: Friday, February 03, 2012 3:26 PM
To: Elecraft List
Subject: Re: [Elecraft] K3 SteppIR Controller

Sorry, forgot to mention that besides the K3 I also have hooked the P3 and
KPA500 and the RS232 to USB for my computer.

Do have available the ports on the KPA500, all the other ports on the
K3 and P3 are in used.

Thanks.

Juan Carlos Munoz.
TG9AJR




On Fri, Feb 3, 2012 at 5:01 PM, TG9AJR Juan Munoz <tg9ajr at gmail.com> wrote:
> I have my K3 and just finishing installing my SteppIR small vertical 
> with the SDA100 Controller and I also order the K3 Transceiver 
> interface connector from the
> SDA100 Controller to the K3.
>
> Does any one knows how is setp up :
> I assume from the DATA IN/RADIO in the SDA100 Controller to the ? on the
K3 ?
>
> Thank you and 73
>
> Juan Carlos Munoz.
> TG9AJR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html