[Elecraft] (K3) Assembly (again) Front head

[Josh Fiden]

I tried that first. In my case it resulted in what I considered an 
unacceptable deformation of the front panel. Maybe I just had a bad 
stackup of tolerances. YMMV!

73,
Josh W6XU

On 12/28/2012 4:14 PM, Don Wilhelm wrote:
> Rick,
>
> Apply some pressure between the board and the front panel metalwork - 
> Squeeze with thumb and fingers while tightening the knurled nut with 
> the other hand.  Tighten until the washer is tight.  That method will 
> do no harm.
>
> 73,
> Don W3FPR
>
>