[Elecraft] K2 Memory and 60 meters management

[Fred Jensen]

How did you program the memories Mike?  Using the K3 Memory Utility, I 
put the CW [channel centered] frequency in VFO A, and the SSB [offset] 
frequency in VFO B for each of the five channels [51-55 for me] and made 
them frequency hoppers.  The K3 scans on VFO A [CW], but it doesn't seem 
to matter, if there is activity there, it stops and a single A/B tap 
changes to SSB on the same channel.  Works for me.

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 2013 Cal QSO Party 5-6 Oct 2013
- www.cqp.org

On 12/28/2012 2:20 PM, Mike Herr wrote:
> I have programed in the CW and SSB freqs for 60 meters into the
> memories. If I directly access the memories I get the proper
> frequencies and modes. But if I set for frequency hopping it starts in
> CW mode and stays in CW, regardless of frequency. So I end up scanning
> all the freqs in the CW mode. Any thought on forcing the proper mode?
>