[Elecraft] Problem Firmware and K3

[Dick Dievendorff]

After parameter initialization you will need to perform the configuration
steps starting on page 46 and calibration steps starting on page 49 of the
Owner's manual and review the menu entries starting on page 52 to enable
options (such as your K144XV). Also consult the installation manuals for the
options you have installed (KBPF3, etc) for their enable procedure.  Often
it's obvious how to enable "optional modules" from the list of K3 menu
entries described on page 52.

You'll need to know what crystal filters you have physically installed in
each slot and the offsets of any 5-pole filters.

This is the sort of information that might have been restored if you had a
saved configuration file.

73 de Dick, K6KR



-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Rudi
Sent: Wednesday, December 26, 2012 1:59 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Problem Firmware and K3

Hello FM,

I did a hard reset: push shift and power on.

After I was successful to upload the K3 firmware now, the dsp1 loaded up.

But have following problems.

Strange noise when I start up the K3.

On bands 24/28/50 I have error PL1

The Main and Config menu are not the same as described in the manual.

Several options that are installed are not activated like my XV144, general
RX, etc....

What will I find next ?

I think I need a configuration file, didn't save mine ;((

Info to solve the problem is welcome

Best 73 - Rudi - ON7CL
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html