[Elecraft] K3 and HRD

[david Moes]

Similar function with logger32 works fine on the K3.    The mode will 
change according to mode definitions in the "bands and modes" table and 
sets mode when I click on a spot.  HRD uses a similar setup.  Is there 
possibly an error in the HRD "band layout" definitions  as set in the 
band manager? possibly entries for the 30s segments.     Mode is set 
based on band layouts and HRD the software sets rig mode,  so i doubt 
it  has much to do with the K3 firmware.

If I am way off here,  I must apologies.   my answer assumes that this 
is similar in V6 as in earlier versions.


On 12/23/2012 6:27 PM, Wayne Burdick wrote:
> Hard for me to imagine how K3 firmware could cause this. Do you have 
> another program with this capability you could try? You could also try 
> sending "FA" (VFO A) commands directly to the K3 using the Command 
> Tester screen in K3 Utility. See the Programmer's Reference for details.
>
> 73,
> Wayne
> N6KR
>
>>
>> I have a really odd bug going on and I don't know if it is the K3 or Ham
>> Radio Deluxe. Whenever I click on a spot, everything works fine 
>> except when
>> it happens to be any frequency in the 30s - that is 3.530 to 3.539, 
>> 7.030 to
>> 7.039, etc.  Any other frequency in the CW band shows up on the K3 
>> and the
>> mode is correctly changed to CW, except in the 30s, where it always 
>> shifts
>> to SSB, even though it is in the CW band.  Anyone know if that's an 
>> issue in
>> the K3 or in HRD? I suspect it is in HRD. Thanks.