[Elecraft] K3 Serial Port Fixed!

[Jim Wiley]

Before you try this on your K3, get a couple of old computer boards 
(junk motherboards, expansion cards, etc) and practice on them. Only 
when you can remove and / or install components from the "junk" boards 
successfully should you try the same with the K3.  Just my 2 cents worth


- Jim, KL7CC


On 12/20/2012 12:03 AM, Martin wrote:
>
> I seem to have the same issue with my K3 I/O board.
> I have a temperature controlled heatgun and will try to solder out the 
> IC if it turns out to be true AND if i knew what temperature to set it 
> to. Anyone?