[Elecraft] Computer died during load

[Don Wilhelm]

Dick,

I assume you are using a K3 and it is locked in MCU Load state.  A hard 
reset in not normally required in that instance.  Look in the K3 manual 
(or the K3 Utility Help file) for the instructions on how to force a 
firmware load.  Follow those instructions 'to the letter', and your K3 
should recover.

The "hard reset" is EEINIT - check the manual for the procedure - you 
will have to restore from a saved configuration or set up all the menu 
parameters manually 'from scratch'.

73,
Don W3FPR

On 12/15/2012 11:14 AM, KC9GSM wrote:
> Anyone know how to do a hard reset. I tried the holding SHIFT and 
> turning on power but it still is locked and display shows MCU. Power 
> button don't work. Can only shut off K3 by removing power. I do have a 
> copy of current config saved but can't get K3 to reload. Anyone have a 
> suggestion??