[Elecraft] KAT500 Kit Builders

[Richard Ferch]

I found the same. The screw in Figure 11 on page 18 is just filling an 
empty hole, so I don't suppose it matters much which kind of washer is 
used for it, and there's nowhere else to use the internal tooth washer 
that was supplied.

Also, based on the parts supplied, the four 4-40 screws for the 
through-board standoffs in figure 26 are apparently supposed to be 3/16" 
(4.8 mm) screws, not 1/4" (6.4 mm) screws as stated in the figure.

73,
Rich VE3KI


John N1JM wrote:

> I also had an extra star washer left over. I wonder if the spit washer on
> page 18 was supposed to be a star washer?