[Elecraft] feedback in K3

[Vic K2VCO]

Make sure you do NOT have SP + PH set. If you do, the speaker and phones will both be on. 
The speaker must be off to avoid feedback if the monitor is on.

On 8/14/2012 7:54 PM, Scott Dunlavey wrote:
> Hello agn... I cant figure what I have set wrong...  I have set up the
> eq on the K3 in transmit the following way...  1=+12  2=+10  3=-1   4=
> -1   5= 0  6= -1  7=0  8 = +2  Rx is the same....  (this is how I had it
> set for the w2ihy EQ...)    as I am trying to set the mic gain and
> monitor levels  I get a lot of feedback in my headphone.very loud..  My
> monitor level is very low... compression has NOT been adjusted because
> of the feedback so that is at zero....  I have a heil pro20 running to
> the front of the K3... any ideas
>
>
> scott

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/