[Elecraft] A Really, Really, Really Dumb Question

[Matthew Pitts]

Buddy,

I believe you would have to physically disconnect the RF and power connections on the main board of the K2, as well as unhooking the connection on the front panel that goes to the integrated KIO interface before the original K2 BNC will work properly.

Matthew Pitts
N8OHU
Sent from my Wireless Device

-----Original Message-----
From: Buddy Brannan <buddy at brannan.name>
Sender: elecraft-bounces at mailman.qth.net
Date: Sun, 18 Sep 2011 20:15:03 
To: <elecraft at mailman.qth.net>
Subject: [Elecraft] A Really, Really, Really Dumb Question

Hi,

Yeah, really. Exceedingly dumb, but I figure I'd better ask anyway.

I have a K2/100. Naturally, this means it has the SO239 antenna connector on the 100-watt amp, It also, of course, still has the BNC connector from the original assembly of the original K2. So, with the KPA100 integrated, is it still possible (with the amp turned off, naturally) to use the BNC antenna connector? It seems to me it's possible, and that I actually did connect an antenna there once, but just want to be sure that it doesn't matter much, so long as the amp is disabled.
--
Buddy Brannan, KB5ELV - Erie, PA
Phone: (814) 860-3194 or 888-75-BUDDY



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html