[Elecraft] K3: No modulation from front panel mic jack

[Bob W4ZY]

They could and they did.

Thanks very much Lyle.  I'm glad it was nothing more serious.

73,
Bob
W4ZY

On Oct 29, 2011, at 2:49 PM, Lyle Johnson wrote:

> Verify the 5-pin connector between the DSP PCB and the FP PCB are mated.  This is located near the headphone jack, mic jack and concentric pots. It is very easy to have the male pins slide next to the female receptacle rather than engage.
> 
> 73,
> 
> Lyle KK7P
> 
>> ... However, SSB from the front jack does not work.  I am using Elecraft MH-2 microphone.  MIC SEL is set to FP.L bIAS.