[Elecraft] K3 Transmitter Gain Cal Failure at 1mW with KXV3a

[Shane DeSeranno]

If you have an external wattmeter (a lot of antenna tuners/dummy loads 
should have this), then go through the wattmeter calibrations to ensure your 
internal wattmeter is reading correctly.

-----Original Message----- 
From: N2ZDB at aol.com
Sent: Friday, October 21, 2011 7:54 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Transmitter Gain Cal Failure at 1mW with KXV3a

Hello K3 Support,

I installed the KXV3a tonight into my K3 and when I went to do the
Gain Calibration it failed on 6 Meters as it was unable to get the required
output.

Any idea why this output could be low on this band (I believe it only
reached an 8 out of the expected 10)?

Thank you,

73's Michael
n2zdb



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html