[Elecraft] Spot button QSYs K3

[Lyle Johnson]

Note that the CWT indicator range, upon which the autospot function is 
based, is only about 200 Hz wide.  In 100 Hz step mode, you'd have to be 
less than 1 step away from zero beat for the function to work.

73,

Lyle KK7P

> I'm using 4.39. I just tested it to double check my previous statement.
> In 10Hz tuning mode it IS changing to 1Hz mode and tuning properly. In
> coarse tune mode (100 Hz), it is not changing tuning rate. I withdraw my
> statement about the 10Hz but stand by the 100Hz.
>
> Thanks for making me check!
>
> 73, Dennis NJ6G
>
>
> On 10/19/2011 3:57 PM, Greg wrote:
>> What firmware version is being used?  When using the auto tune
>> function the radio should go into fine tune mode and then turn it off
>> after the tuning is done.
>> 73
>> Greg
>>
>>
>> On Wed, Oct 19, 2011 at 3:52 PM, Dennis Moore<dennis at mail4life.net
>> <mailto:dennis at mail4life.net>>  wrote:
>>
>>      Others have mentioned the Autospot feature, and here's an
>>      observation on
>>      that as it relates to your issue of a large freq change.
>>
>>      If my freq resolution is at 10Hz or 100Hz and I try to Autospot, I
>>      will
>>      get a 2kHz shift as you described. If, however, I am set to 1Hz
>>      resolution, the Autospot feature brings the frequency right where
>>      it is
>>      supposed to be.
>>
>>      73, Dennis NJ6G
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>