[Elecraft] Send a simple tone

[Ron D'Eau Claire]

Don, just press TUNE as Dennis noted. The K3 will transmit a carrier at the
initial level set in CONFIG:TUN PWR menu. Once you press TUNE, you can
adjust the RF output of the K3 to anything within its range from almost zero
to 100 watts by turning the PWR knob. 

Ron AC7AC

-----Original Message-----


Dear Group.

I need to figure out how to send a simple tone output from the K3 to my 
amp to be able to check power output.

I dont have a CW keyer and can not figure out how to set up a simple 
switch to key a tone.

I ultimatly want to plot K3 drive power to amp output power for each of 
the bands.   I am sure if I had a CW keyer it would be easy, but I was 
hoping I could do something with a simple rocker switch.

I am sure there is a way to do it.

Thanks
Don

~73
Don
KD8NNU

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html