[Elecraft] Send a simple tone

[Greg]

Don,

Use the K3 TUNE button (not ANT TUN)  This will do what you want and be at
the power level set with the power control.  If you want to use a lower
setting than what is set with PWR go to CONFIG TUN PWR and set it to
whatever power  you want to use.

73
Greg
AB7R



On Fri, Oct 7, 2011 at 2:42 PM, <goldtr8 at charter.net> wrote:

> Dear Group.
>
> I need to figure out how to send a simple tone output from the K3 to my
> amp to be able to check power output.
>
> I dont have a CW keyer and can not figure out how to set up a simple
> switch to key a tone.
>
> I ultimatly want to plot K3 drive power to amp output power for each of
> the bands.   I am sure if I had a CW keyer it would be easy, but I was
> hoping I could do something with a simple rocker switch.
>
> I am sure there is a way to do it.
>
> Thanks
> Don
>
> ~73
> Don
> KD8NNU
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>