[Elecraft] KRC2 Setup

[Jim Brown]

Thanks Iain.  You would think that would be in the doc for the KRC2.  
Now that you mentioned it, I see it in the K3 doc, but ONLY in the Menu 
table.

73, Jim K9YC

On 5/22/2011 12:38 PM, iain macdonnell - N6ML wrote:
> There's a setting in the K3 that optionally maps the 6m band to 10m.
> If that setting is enabled, you'll be trying to pass 6m through your
> 10m BPF, which probably won't work well :) Go to CONFIG:KRC2 and tap
> the '1' button until you see "bnd6=b6"
>
> 73,
>
>      ~iain / N6ML
>
>
>
> On Sun, May 22, 2011 at 6:48 PM, Jim Brown<jim at audiosystemsgroup.com>  wrote:
>> I've been loaned a W3NQN bandpass filter setup that uses an Array
>> Solutions FM6 switch box controlled by a KRC2 connected to the Aux Bus
>> of my K3. Everything seems to work fine on 160-10M, with those bands for
>> which there are no filters being bypassed, but 6M doesn't get through
>> the switching network.  There's a KRC2 config utility that I've
>> downloaded and installed, and it fails to show any options for 6M other
>> than for analog voltage band-decoding.  It does tell me that I have the
>> latest version of the KRC2 firmware installed.
>>
>> Documentation on using the KRC2 and the config utility is something that
>> only the programmer's mother could love. It refers to maps, but doesn't
>> tell me how to set up those maps to cover 6M. Can anyone help me get
>> this running by some means other than adding switches to bypass the
>> switching matrix entirely?
>>
>> Thanks and 73, Jim K9YC
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>