[Elecraft] KRC2 Setup

[iain macdonnell - N6ML]

There's a setting in the K3 that optionally maps the 6m band to 10m.
If that setting is enabled, you'll be trying to pass 6m through your
10m BPF, which probably won't work well :) Go to CONFIG:KRC2 and tap
the '1' button until you see "bnd6=b6"

73,

    ~iain / N6ML



On Sun, May 22, 2011 at 6:48 PM, Jim Brown <jim at audiosystemsgroup.com> wrote:
> I've been loaned a W3NQN bandpass filter setup that uses an Array
> Solutions FM6 switch box controlled by a KRC2 connected to the Aux Bus
> of my K3. Everything seems to work fine on 160-10M, with those bands for
> which there are no filters being bypassed, but 6M doesn't get through
> the switching network.  There's a KRC2 config utility that I've
> downloaded and installed, and it fails to show any options for 6M other
> than for analog voltage band-decoding.  It does tell me that I have the
> latest version of the KRC2 firmware installed.
>
> Documentation on using the KRC2 and the config utility is something that
> only the programmer's mother could love. It refers to maps, but doesn't
> tell me how to set up those maps to cover 6M. Can anyone help me get
> this running by some means other than adding switches to bypass the
> switching matrix entirely?
>
> Thanks and 73, Jim K9YC
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>