[Elecraft] K3 Hi Cut & Low Cut granularity bug?

[Ed Muns]

I don't see this as a limitation because I only use HI CUT and LO CUT in SSB
where 50 Hz steps is just fine.  For CW and RTTY, the 10 Hz steps of SHIFT
and WIDTH are great.

Ed - W0YK

N6KR wrote:
> Providing HI CUT and LO CUT when SHIFT is configured for 10 
> Hz increments would require a substantial rewrite to the K3 
> firmware. If you'd like to use LO and HI CUT, for now you'll 
> need to use 50-Hz steps.