[Elecraft] K3 Hi Cut & Low Cut granularity bug?

[Vic K2VCO]

It's not a bug, it's a documented limitation.

Actually, it can be a feature: if it's set to 10 Hz and you tap one of the knobs, it 
displays the shift or the width without changing the control's function!

On 6/7/2011 6:51 PM, Rich - K1HTV wrote:
> Joe,
>    I'm aware of the SHIFT granularity being settable from 50 Hz to 10 Hz. What I
> was questioning is why, when this change is made, that the K3's  HI CUT and LOW
> CUT controls are disabled. After you set  CONFIG:PB CTL to 10 Hz, when you press
> either HI-CUT or LOW-CUT. nothing happens and you can no longer roll off either
> side of the passband as you could when PB CTL is configured to 50 Hz.  Is this
> an undocumented feature? If so, I think it is a bad one.
>
> 73,
> Rich - K1HTV
>
> = = =
>
> -----Original Message-----
> From: Joe Subich, W4TV [mailto:lists at subich.com]
> Sent: Tuesday, June 07, 2011 19:42 PM
> To: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] K3 Hi Cut&  Low Cut granularity bug?
>
>
>> Also, when the SHIFT granularity (CONFIG:PB CTL) is changed from 50Hz
>> to 10Hz,>  the Hi Cut and Low Cut controls do not work at all! Is this
>> a BUG ora FEATURE? I'm presently using K3 firmware update MCU
>> 4.36 .
>
> Feature ... as documented every since the 10 Hz steps for shift/width was first
> provided in beta testing.
>
> 73,
>
>      ... Joe, W4TV

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/