[Elecraft] issue with new K3

[Steve Coates]

I found the issue. Had the filter in the wrong slot.

On Sat, Jun 4, 2011 at 1:50 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:
>  Steve,
>
> Have you done the first step in the Calibration Procedures?  Go to the menu
> CONFIG: VCO MD, set the parameter to CAL and exit the menu to allow the
> routine to run.
> If you do not see that menu item, go to TECH MD and turn it on, then you
> should see the entry.
>
> 73,
> Don W3FPR
>
> On 6/4/2011 1:06 PM, Steve Coates wrote:
>>
>> I just finished building my K3/10. For one of the calibration steps I
>> am trying to receive WWV. It seems that receive is not working on the
>> K3. I have a steady hiss no mater if it is hooked to a dummy load or
>> an antenna.
>>
>> This is a basic K3 with no options.
>>
>> Any ideas?
>> Steve
>> N8JAF
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>