[Elecraft] issue with new K3

[Don Wilhelm]

  Steve,

Have you done the first step in the Calibration Procedures?  Go to the 
menu CONFIG: VCO MD, set the parameter to CAL and exit the menu to allow 
the routine to run.
If you do not see that menu item, go to TECH MD and turn it on, then you 
should see the entry.

73,
Don W3FPR

On 6/4/2011 1:06 PM, Steve Coates wrote:
> I just finished building my K3/10. For one of the calibration steps I
> am trying to receive WWV. It seems that receive is not working on the
> K3. I have a steady hiss no mater if it is hooked to a dummy load or
> an antenna.
>
> This is a basic K3 with no options.
>
> Any ideas?
> Steve
> N8JAF
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>