[Elecraft] K3 Stumped.

[N2TK, Tony]

Weird, but I have the same problem with the B encoder on one of my K3's. If
I pull slightly on VFOB nothing changes. If I push on it slightly it works
fine. I guess the first thing I should try is to resolder the connections on
the encoder. 
Any other ideas?
N2TK, Tony 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Edward Dickinson, III
Sent: Sunday, January 30, 2011 4:20 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 Stumped.

Hi Dohn,

Interestingly, I had the 1st problem I've ever noted with the "B
VFO/Encoder" last night.  As I was attempting to change the IF DSP the value
would either not change or stick and shift several values at once.  A couple
of taps with my fingernail on the knob seems to have cleared it right up.
As well, I did have computer software running which was interfaced to the
K3.


73,
Dick - KA5KKT

----------------------------------------------------------------------------
----

I checked the encoder and it was connected properly.  I can't help but
thinking I'm doing (or not) doing something right.  Seems easy enough.

If this hasn't been a commonly made mistake, I have to wonder about the
encoder at VFO B.
73
Dohn Smythe  N8EWY


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html