[Elecraft] K3 Slow power change

[Julian, G4ILO]

Yes, if you don't have sufficient audio drive. Long-press DISP so that the
ALC scale is visible then adjust the input level for a steady 4 - 5 bars
reading. (This assumes you are using the DATA mode not USB.)


Rich - K1HTV wrote:
> 
> K3 Slow power change
> 
> Making a small incremental change in the power output using the PWR
> control will cause the slow recovery if done before or during a WSPR
> transmission.
> 
> Is this normal?
> 
> 


-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Slow-power-change-tp5966743p5966854.html
Sent from the Elecraft mailing list archive at Nabble.com.