[Elecraft] K2 VCO Alignment

[Don Wilhelm]

On 1/21/2011 1:07 PM, Paul Agoglia wrote:
> I am up to page 64 of the assembly instructions for my K2 serial 7059.  When performing the VCO Alignment, I started off with a reading of 8.2 volts.  When adjusting L30 I got no changes at all, although the directions call for adjusting the slug until 6 volts is obtained.
> Any help would be appreciated.
>
> Thanks,
>
> 73 de WN2K
>
> Paul Agoglia
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>