[Elecraft] Setting K3 default filter BW

[Don Wilhelm]

  Scott,

There are several combinations available to you,  If you set the width 
manually, and power off and then on, the width setting will be 
remembered.  There is also the I and II settings which are "floating 
settings" that can be used as well as the NORM (400 Hz) and the Norm1 
and Norm2 settings that can be almost anything you wish.

These settings are available from the K3 front panel.  I am not sure 
about the availability of them from any particular computer 
application.  All these settings are possible through computer control 
(see the K3 Programmer's Reference), but not all may be implemented in a 
particular piece of software.

73,
Don W3FPR

On 1/19/2011 10:48 PM, Scott Dickson, W5WZ wrote:
> Hi All!
>
> I'm a new K3 owner (#0251) as of last Friday.  I have successfully obtained
> and learned how to use most of the features in:
> 	K3 Utility software
> 	K3_EZ software
>
> Using K3 Utility, I checked for latest versions of all firmware, and
> successfully loaded to the K3.
>
> My K3 has the following filters, installed in the correct positions and
> correctly listed on the crystal filter section of the K3 Utility software.
> 13kHz
>   6kHz
> 2.8kHz
> 2.1kHz
> 1.0kHz
>
> I have both a C3 and D9 version of the owners manual, and have not yet found
> the answer to my question in either of them.
>
> When in CW mode, the K3 defaults to the FL5 (1.0kHz) filter, and sets the BW
> to 400Hz.  I was wondering if or where that default BW setting could be
> altered?  I know the BW can be changed with the WIDTH knob.
>
> --Scott, W5WZ
>