[Elecraft] [K2] Ooof.. Update

[Don Wilhelm]

  Brian,

Actually, that does not make a lot of sense.  The T/R switch is too far 
removed from the KNB2 for that to be a problem (unless you were really 
wild with the soldering iron :-) ).

Try jumpering  (with a piece of bent wire) between pins 1 and 6 of the 
J12 header.  If receive comes back to life, you have a problem on the 
KNB2 board.

Let us know the results.

73,
Don W3FPR


On 1/18/2011 10:26 PM, Brian Denley wrote:
> I am beginning to think I may have wacked or damaged the PIN diode for the
> T/R switch while adding the resistor for the KNB2.  That might explain no
> receive or transmit  that I am getting now.  Does that make sense?
> Brian
> KB1VBF
> http://home.comcast.net/~b.denley/index.html
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>