[Elecraft] clear RIT upon tuning in K3?

[Guy Olinger K2AV]

The N1MM {CLEARRIT} macro sends the correct K3 command if the rig is
declared as a K3.  My run F3 string in N1MM is ...

   "TU * {CLEARRIT}"

  ...  without the quotes and those are braces, not paretheses.

73, Guy.

On Mon, Jan 10, 2011 at 3:55 PM, Wayne Burdick <n6kr at elecraft.com> wrote:
> RIT CLR can be done either from the front panel switch, an "RC;"
> command, or an "SWT53;" switch emulation command, even while you're
> transmitting.
>
> 73,
> Wayne
> N6KR
>
>
> On Jan 10, 2011, at 12:13 PM, Mark n2qt wrote:
>
>> Is there a way to zero the RIT control when tuning the main tuning
>> knob?
>>
>> During the rtty contest I would ride the RIT control while running
>> and then
>> forget to
>> zero it when changing to S&P.
>>
>> I've looked through the K3 manual and programmers reference along with
>> looking
>> through the N1MM manual (If there was a macro that would execute when
>> changing
>> from RUN to SP I could do it that way).
>>
>> Mark n2qt
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>