[Elecraft] KPA100 Page 44 Resistance Measurements

[K1FFX]

The instructions with the resistance check chart on page 44 of the Rev G
KPA100 manual are very explicit about the measurement on J3, namely that the
electrolytic capacitor in the 12V line causes this measurement to appear as
a short initially, and then slowly go up to a resistance value within range.

I am seeing exactly the same behavior on the Q1 and Q2's collectors and
D13's cathode, starts at 0 ohms and ramps up to an in-range value in a
number of seconds.  Since the instructions were so explicit about J3 and
didn't mention these other measurements, I'd like to make sure that this
behavior is OK.

Thanks -

Bruce




-----
Bruce Rosen
K1FFX

-- 
View this message in context: http://elecraft.365791.n2.nabble.com/KPA100-Page-44-Resistance-Measurements-tp5905235p5905235.html
Sent from the [K2] mailing list archive at Nabble.com.