[Elecraft] Data modes issue

[Jim Littlefield]

Positive. My sound card is a US Interface Navigator. I can turn it's monitor speaker completely off and listen to the K3's monitor. 

- Jim WN1X

On Jan 8, 2011, at 2:31 PM, "Joe Subich, W4TV" <lists at subich.com> wrote:

> 
> Are you sure you're hearing the audio from the K3 monitor and
> not from other speakers attached to the computer?  What sound
> card software are you using?  Are you sure it is configured to
> use the soundcard attached to the radio and not the computer
> "default" sound card if you have more than one (e.g., an interface
> with built-in sound card)?
> 
> 73,
> 
>   ... Joe, W4TV
> 
> On 1/8/2011 2:04 PM, Jim Littlefield wrote:
>> Yes, I definitely have the MIC SEL set to LINE IN and the LINE IN gain
>> at 30.
>> 
>> 
>> On 1/8/2011 1:57 PM, John Ragle wrote:
>>> Check in particular...
>>> 
>>> MIC SEL = LINE IN
>>> 
>>> also
>>> 
>>> LIN IN set to ~10-30 depending on band...
>>> 
>>> My mic gain runs about "LINE 30" and the SignaLink (IF USING) has TX @
>>> 9 O'Clock and RX @ 11 or 12 O'Clock. (Again, IF USING SignaLink, both
>>> jumpers that deal with audio olume are set to the "high" setting...see
>>> instructions.)
>>> 
>>> John Ragle -- W1ZI
>>> 
>>> =====
>>> 
>>> On 1/8/2011 1:47 PM, Jim Littlefield wrote:
>>>> Just got my new K3 and everything is great about it except, sound card
>>>> data modes (PSK31, etc.) are not working. I put the radio in Data A
>>>> mode. When I transmit, the rig is keyed, I can hear audio via the
>>>> monitor function, but nothing is transmitted. I have tried cranking the
>>>> Mic gain (actually the line in gain) way up, but that doesn't help. I
>>>> have also confirmed the transmitter is not in test mode.
>>>> 
>>>> Any suggestions?
>>>> 
>>> 
>>> 
>> 
>>